Quatech AirborneDirect ABDG-ET Series Guide de l'utilisateur télécharger pdf (Page 2)

AirborneDirect™ Serial Device Server Quick Start Guide Quatech, Inc.

100-8107-110 2 February 2011

Getting Started:

1. Configuring Device – Enterprise Serial (ABDG-SE-DP5XX)

The ABDG-SE-DP5XX family does not have an Ethernet port for initial configuration so initial configuration

can be performed through the serial port. To do this it is necessary to connect using the serial connector.

2. Connect a Host Computer

Connect the serial pigtail connector to the serial port on a host computer.



It may be necessary to use a gender changed that includes a Null Modem adapter.

3. Interacting with the AirborneDirect™ device

On the Host computer, use a terminal emulation program to interact with the device issuing Quatech

Command Line Interface (CLI) commands. CLI commands let you request status or change parameter

settings. Press the Enter key (<CR>) after each command line you type. After the module starts, type the

following CLI command to log in (you must log in before CLI commands can be recognized):

Table - UART Authentication

CLI Command

Description

Send Break Sequence

The serial port starts up in a listen mode waiting for a request for

a data tunnel. To access the CLI mode in which set-up can take

place the break sequence must be sent.

The default break sequence for the device is ÿ~ABD

The sequence must be sent with no trailing characters.

If received correctly the device will respond OK.

auth dpac dpac <CR>

The module responds with OK, indicating that it executed the

command successfully. (If you did not receive OK, check the

settings in your terminal emulation program).



You will have to break into CLI mode and log into the module after any reset or restart.

1 2 3 4 5 6 7 8 9

Pas de commentaire

Quatech AirborneDirect ABDG-ET Series Guide de l'utilisateur Page 2