Quatech Audio/Video Capture USB 2.0 Spécifications télécharger pdf (Page 120)

7-16 z.one ultra and z.one ultra sp OPERATOR MANUAL

Figure 7-12. Linear and Virtual Apex Array Icons and Softkeys

Dual Mode Turning on Dual imaging mode enables the system to display two side-by-side

images (referred to as image A and image B for the purpose of this document).

Only nonstrip imaging modes (i.e., 2D/B-Mode, Color Doppler, or Power Doppler)

are supported for Dual image mode.

■

In basic Dual mode, one of the two images displayed on the screen is active

(live updating) while the other image is static (not updating).

■

In Simultaneous Dual mode, both images (A and B) displayed on the screen

are dynamically active (live updating). One image is selected as the active

image, indicated by the white Z (Zonare logo).

■

You can Freeze and Pan Zoom independently on either image (see below).

■

Color Doppler Mode can be applied to just one side, if desired.

■

User controls are applied as follows during Simultaneous Dual mode:

• Preprocessing functions (A Output, C, etc.) - Active image only

• Postprocessing functions (Gain, Persistence) - BOTH images affected

 To Activate Dual Mode

1. Activate Dual mode as follows:

2. System enters Dual mode. Optimize orientation on patient’s anatomy, user

settings, and image quality for initial image displayed (Image A).

3. To toggle to (activate) other Dual image (Image B):

Linear Array Format is Active

Virtual Apex Array Format is Active

SmartCart

Press Dual button.

SmartCart sp

Press Menu button; then select Dual.

Scan Engine

a. Use Menu Control to highlight and select Dual:

Off.

b. Toggle to initial Dual image (A) using Menu

Control left/right arrows.

SmartCart

Press ENTER button.

SmartCart sp

Press Enter/Select button.

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 403 404

Pas de commentaire

Quatech Audio/Video Capture USB 2.0 Spécifications Page 120