Quatech Audio/Video Capture USB 2.0 Spécifications télécharger pdf (Page 65)

100

101

z.one ultra and z.one ultra sp OPERATOR MANUAL 4-5



shows whether the battery is charging and how much charge is left. See Table 4-3

on page 4-9.

If the optional ZPak battery is used, two status icons display on the SmartCart/

SmartCart sp

LCD monitor: One for the ZPak battery and the other for the Scan

Engine

internal battery.

Figure 4-4. Scan Engine Battery Slot

 To Install Battery

NOTE: Remove the Scan Engine from the SmartCart/SmartCart sp before

installing/replacing the battery.

1. Verify the charge on the battery (see “Checking Scan Engine Battery Charge”

on page 4-5).

2. Locate the battery slot on the left side of the Scan Engine (Figure 4-4).

3. Line up the prominent groove on the battery with the corresponding tongue on

the left inside surface of the battery slot.

4. Push the battery in until it is fully locked in place.

5. The battery charge LEDs to the right of the battery pocket will light up showing

the amount of charge left.

 To Eject Battery

1. Push the battery release latch to the right of the battery slot.

2. Remove the battery.

Checking Scan

Engine Battery

Charge

There are two locations on the Scan Engine for checking battery charge:

1. A status icon displays below the menu of the Scan Engine screen.

• The icon displays the % of charge remaining. In Figure 4-5, the remaining

charge is 100%.

• The icon turns amber when less than 25% of the charge remains.

• The icon flashes, followed by a system shutdown message when less than

5% of the charge remains.

Battery Charge LEDs

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 403 404

Commentaires sur ces manuels

Pas de commentaire

Quatech Audio/Video Capture USB 2.0 Spécifications Page 65

Commentaires sur ces manuels