Quatech Audio/Video Capture USB 2.0 Spécifications télécharger pdf (Page 262)

10-6 z.one ultra and z.one ultra sp OPERATOR MANUAL

The ECG trace is part of the Cardiac Exam Preset and automatically scrolls at the

bottom of the 2D image. In strip modes (M, PW, and CW modes) the ECG trace

will default to the top of the strip. The ECG trace position can be adjusted

anyplace within the strip box.

WARNING: The ECG is not intended for ECG diagnosis. It must not be used for

intraoperative applications of the heart. Use only the recommended patient cable

supplied by ZONARE. Make sure that bare parts of the electrodes and the patient

do not come in contact with conductive parts, such as metal examination beds,

trolleys, and similar items.

WARNING: When using the ECG input and defibrillation is required, always

disconnect the ECG cable from the system before defibrillation and keep cable

away from conductive surfaces.

NOTE: ZONARE recommends the following ECG patient cables and lead wires

from Advanced Medical Cables (www.advantagemed.com):

• AMC LW-3700024/31 (International patient lead wire replacements)

• AMC LW-3700024/3A (Domestic patient lead wire replacements)

• AMC CB-83340 (ECG trunk cable)

• AMC CB-33598-00 (Accessory cable for use without lead wires)

 To Use ECG Function

■

A transducer (such as the P4-1c or P10-4 transducer) needs to be initialized

for the ECG to operate.

■

Plug the ECG cable into the ECG port on the SmartCart (see Figure 2-1 on

page 2-2) to display the ECG trace.

■

Connect the three patient leads to the patient.

 To Activate ECG Trace

1. Press the ECG key on the SmartCart QWERTY keyboard (Figure 10-4). This

will activate the ECG softkey controls (Figure 10-5).

Figure 10-4. ECG Key on SmartCart QWERTY Keyboard

1 2 ... 257 258 259 260 261 262 263 264 265 266 267 ... 403 404

Pas de commentaire

Quatech Audio/Video Capture USB 2.0 Spécifications Page 262