Quatech Audio/Video Capture USB 2.0 Spécifications télécharger pdf (Page 317)

z.one ultra and z.one ultra sp OPERATOR MANUAL 12-7



Figure 12-7. Image Store/Print Buttons Screen: Print Section

2. In the Print section of the screen, check the box to the left of the Network/USB

Printer selection (

Figure 12-7 above).

3. In the drop-down menu next to Network/USB Printer, select the target USB

printer. Select Apply to save the settings.

Postscript Level 3 Network-Capable Color Printer

NOTE: The following section assumes that a Postscript Level 3 color printer has

already been connected to the System (power and USB/network cables properly

connected). For information on installation/hook-up, please refer to the document

provided in the installation kit shipped from

ZONARE with each printer. This

information is also provided in the Service Manual.

 To Set Up

1. Power on the System and allow it to fully boot.

2. Open the paper tray of the unit and install the desired paper.

3. Power on the printer by pressing the ON button.

 To Print Reports

1. Perform the desired OB/GYN calculations and measurements on the System.

2. At the conclusion of the OB/GYN measurement process, to manually trigger

the print of an OB Report, select the Print softkey on the Calculations | Report

page.

3. If the OB Report printing was configured for Print at end of exam, the OB/GYN

Report will automatically be output to the Postscript printer upon ending the

current exam.

NOTE: For information on configuring the System for OB/GYN Report printing with

a Postscript Level 3 color printer, refer to

“Measurement Accuracy” on page 9-51.

1 2 ... 312 313 314 315 316 317 318 319 320 321 322 ... 403 404

Pas de commentaire

Quatech Audio/Video Capture USB 2.0 Spécifications Page 317